Screen printing is widely used to form metal contacts on solar cells, but the process can introduce degradation that lowers device performance. The issue is particularly important for copper-plated silicon heterojunction (HJT) cells, which are being pursued as a way to reduce metallization costs and reliance on expensive silver.
Mechanical pressure and thermal treatments during screen printing can damage the sensitive passivating contact structures of HJT cells, increasing recombination losses and reducing conversion efficiency. Understanding these degradation mechanisms is therefore necessary for optimizing metallization without compromising cell performance.
Where the damage comes from
Researchers in China investigated the mechanisms behind screen-printing-induced degradation in copper-plated HJT cells and developed a method to mitigate the effects, potentially improving their suitability for large-scale manufacturing. Lang Zhou, the corresponding author, said the photoresist printing step differs fundamentally from conventional silver-paste screen printing.
In silver-paste printing, screen openings account for only 2–5% of the total area, while an emulsion layer covers the rest and prevents direct contact between the mesh and the wafer. By contrast, full-area photoresist coating typically uses a screen without emulsion coverage to ensure uniform resist deposition across the wafer. As a result, the mesh comes into direct and extensive contact with the wafer during each printing cycle, Zhou said.
Earlier production data showed conversion efficiency declining from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses were mainly attributed to reductions in open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation increased from 0.61% with a new screen to 11.0% after 15,000 printing cycles.
Using three-dimensional confocal microscopy, the scientists identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, suggesting damage to the sensitive amorphous silicon/crystalline silicon interface.
An emulsion buffer with a trade-off
To address the problem, the researchers developed an emulsion buffer layer intended to prevent direct contact between the screen mesh and the wafer surface. They evaluated six patterns with emulsion coverage ratios ranging from 2.9% to 16.6%.
The results showed a trade-off between mechanical protection and photoresist coating uniformity: higher emulsion coverage reduced damage but impaired ink distribution. An emulsion coverage ratio of 4.7% provided the best balance, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity.
The researchers attributed the improvement to the emulsion layer preventing direct contact between the screen mesh and the wafer, thereby reducing cumulative mechanical damage to the passivation layers. Zhou said the findings show that a relatively simple modification to screen design can substantially mitigate printing-induced degradation and offer a practical approach to improving manufacturing reliability for copper-plated HJT cells.
The findings were published in Solar Energy in the paper “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells.”
Copper metallization momentum
Interest in copper metallization is growing as an alternative to silver-based contacts in HJT cells. In April 2026, researchers at China’s Nankai University developed a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating. The approach addressed adhesion, contact resistance and stability challenges at the ITO interface.
Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT solar cell. The silver-free device showed a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. The results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance remain necessary.
